The URS600CE solvent recycler provides a shop with clean recycled solvent every day. Typical solvents include paint thinner, gun wash solvent and acetone. With a Uni-ram solvent recycler the shop’s environmental footprint shrinks and the shop saves money. Solvent purchases and the cost for used solvent transported off-site drop by approximately 90%.
The URS900CE provides 25 L of clean recycled solvent from each recycling batch.
The URS900CE is for owners that want features not offered on the basic URS600CE solvent recycler. Features on the URS900CE, not on the URS600CE are:
1) lowering of the heater wattage to make the boiling phase less vigorous; this is important for low boiling point solvents such as acetone.
2) increasing the post heat time to make the solvent residue dryer thus increasing recycling efficiency.
The work shop of collision repair shops in many countries is classified as zone 1 of the gas group by the National Electrical Code due to the intermittent presence of solvent vapors. Uni-ram solvent recyclers are approved for use in collision repair shops, all other locations classified as zone 1of the gas group as well as in non classified locations.
IMPORTANT SAFETY AND USAGE ADVISORY
Do not recycle solvents that includes Nitrocellulose due to its low auto ignition temperature and Peroxides due to its thermal decomposition. Check the Safety Data Sheet of both the solvent and waste material for the presence of these 2 substances.
Pour 25 L of used solvent into the liner bag in the distillation tank. Press Start to turn on the heating element. The solvent vaporizes, travels through the condenser where it is cooled to a liquid by an electric fan and then flows into the receiving pail. The residue that remains in the heat resistant liner bag is transferred to a waste drum for later disposal. Most residues including waste paint is disposed of as a hazardous material.
is the same as URS900CE except dirty solvent is pumped directly into the distillation tank and clean recycled solvent is pumped from the receiving pail to an external clean container. Pumps are activated by turning a timer.
No pails to lift, no solvent to pour. Shop safety improves, less back strain and less solvent spillage.
The URS900EP2CE is designed to connect to and recycle used solvent from E-model spray gun and pressure pot cleaners such as UG4000E, UG6000E, UG5000EW, UG6000EH, UPP6500E and UG7500E. These units are equipped with special pails and hoses to permit easy flow of solvent to and from the solvent recycler.
The transfer system of the URS900EP2CE includes:
Two dual diaphragm pumps, two 5-minute timers, a receiving pail, hoses and fittings.
is a URS900CE with a stainless steel condenser and fittings to resist acidic and corrosive solvents. URS900CE has a copper condenser.
Toll FREE: 1-800-417-9130
For Sales/Products Inquiry Email: firstname.lastname@example.org
For for Technical Support Email: email@example.com
Address: 381 Bentley St, Markham, ON L3R 9T2
Uni-ram Head Office381 Bentley StreetMarkham, OntarioCanada L3R-9T21-800-417-9133
Enter the destination URL
Or link to existing content