The URS900 solvent recycler provides a shop with clean recycled solvent every day. Typical solvents include paint thinner, gun wash solvent and acetone. With a Uni-ram solvent recycler the shop’s environmental footprint shrinks and the shop saves money. Solvent purchases and the cost for used solvent transported off-site drop by approximately 90%.
The URS900 provides 6.6 gal of clean recycled solvent from each recycling batch.
|Heating Element||2100 W||1500 W|
|Tank Capacity||5 gal, 25L||5 gal , 19L|
|Computer display with menu showing additional features||Yes||No|
The URS900 is for owners that want features not offered on the basic URS500 solvent recycler. Features on the URS900, not on the URS500 are:
1) lowering of the heater wattage to make the boiling phase less vigorous; this is important for low boiling point solvents such as acetone.
2) increasing the post heat time to make the solvent residue dryer thus increasing recycling efficiency.
The work shop of all collision repairs shop is classified as a class 1 division 2 by the National Electrical Code, due to the intermittent presence of solvent vapors. The paint mixing room is classified as the more stringent class 1 division 1 area, as solvent vapors are normally present. Uni-ram solvent recyclers are approved for use in all collision repair shops, other class 1 division 1 and 2 locations and non classified locations.
IMPORTANT SAFETY AND USAGE ADVISORY
Do not recycle solvents that includes Nitrocellulose due to its low auto ignition temperature and Peroxides due to its thermal decomposition. Check the Safety Data Sheet of both the solvent and waste material for the presence of these 2 substances.
Is the same as URS900 except dirty solvent is pumped directly into the distillation tank and clean recycled solvent is pumped from the receiving pail to an external clean container. Pumps are activated by turning a timer.
No pails to lift, no solvent to pour. Shop safety improves, less back strain and less solvent spillage.
The URS900EP2 is designed to connect to and recycle used solvent from E-model spray gun and pressure pot cleaners such as UG4000E, UG6000E, UG5000EW, UG6000EH, UPP6500E and UG7500E. These units are equipped with special pails and hoses to permit easy flow of solvent to and from the solvent recycler.
The transfer system of the URS900EP2 includes:
Two dual diaphragm pumps, two 5-minute timers, a receiving pail, hoses and fittings.
Is a URS900 with a stainless steel condenser and fittings to resist acidic and corrosive solvents. The URS900 has a copper condenser with brass fittings.
WATER: Use the URS500SS to recycle water or used solvent that includes water. Water can corrode a copper condenser but not a stainless steel condenser.
Is the same as URS900SS except dirty solvent is pumped directly into the distillation tank and clean recycled solvent is pumped from the receiving pail to an external clean container. Pumps are activated by turning a timer.